Microsoft makes no warranties and excludes all representations, warranties, and conditions whether express, implied, or statutory. Microsoft cannot guarantee or endorse the accuracy of any information or of any solution that is presented by Microsoft or by any mentioned third-party provider. Because Microsoft must respond to changing market conditions, this information should not be interpreted to be a commitment by Microsoft. There might also be other third-party providers or third-party solutions that this article does not describe. Microsoft does not specifically recommend any third-party provider or third-party solution that this article might describe.
This solution is available through Microsoft or through a third-party provider. The information and the solution in this document represents the current view of Microsoft Corporation on these issues as of the date of publication. This article discusses how to install and configure the OLE for Point of Sale (OPOS) drivers for the MagTek USB Mini Magnetic Stripe Reader in Microsoft Dynamics Retail Management System (RMS) Store Operations. THE INFORMATION THAT IS CONTAINED HEREIN IS CREATED IN RESPONSE TO EMERGING OR UNIQUE TOPICS, OR IS INTENDED TO SUPPLEMENT OTHER KNOWLEDGE BASE INFORMATION. RAPID PUBLISHING ARTICLES PROVIDE INFORMATION DIRECTLY FROM WITHIN THE MICROSOFT SUPPORT ORGANIZATION. I setup the driver, and it still does not read, unless I open the separate program, and even then, it only reads into the windows in the MSR605.Source: Microsoft Support RAPID PUBLISHING However, I have not been able to get that to work. Connect Power-in cable to Power supply and AC receptacle (110V~240V).ĥ.
Connect USB of the MSR605 signal cable to a free serial port. Setup the usb driver(for windows xp or vista) and Setup the driver for MSR605,all driver in the cd.ģ.
In the MSR Programmers Manual, it states the following:Ģ. Is there a way to utilized a Magnetic Reader/Writer like the MSR605 as a simple reader? However, I am unable to get it to read info from the cards, unless I have their software open, which sets the card reader to "Read Mode". I recently purchased the MSR605, which can write as well as read cards. There is no programming necessary, except to parse the data, etc. These magnetic swipe readers essentially just dump whatever data is on the card to the screen cursur, as if it was typed.įor example, if you had notepad open, and you swiped a card, then it would output the data into notepad. We have an application that allows a CC Reader (such as the MSR206) to be swiped to enter in a credit card number.
0 kommentar(er)
